BF25D/30D BF25D-BF30D — Sep '94

BF25D-BF30D b. ASSEMBLY 1) Tighten a new 8 x 26 mm stud bolt fully, then back it off 114 to 314 turns out. [l J 8 x 26 mm STUD BOLT I 2) With the friction block disc surface facing up (i.e. engine under case side), install one of the friction blocks onto the friction lever shaft by aligning the cutout in the friction block with the boss on the swivel case. [2] Friction Block Viewed From Top: [l] CUTOUT FRICTION BLOCK >AUTION [4] BOSS Check the two friction block disc surfaces for wear. If both or either one is worn, replace with new ones as a set. Check the friction block disc surface for conta- mination with grease. Degrease if necessary. [5] Friction Block Viewed From Side:

[3] FRICTION BLOCK [6] SWIVEL CASE 3) Install the friction plate on the mount frame and loosely tighten the two 6 x 12 mm flange bolts. Pushing the friction plate toward the mount frame in the direction shown by arrow, tighten the 6 x 12 mm flange bolts securely. [l] FRICTION PLATE 6 x 1 2 (2) , [41 + [3] FRICTION PLATE - [2] MOUNT FRAME \ 6 x 12 (2) Push. I) 13-2