BF25D/30D BF25D-BF30D — Sep '94

B F25D.B F30D With the friction block disc surface facing down (i.e. friction plate side), install the other friction block by aligning the cutout in the friction block with the boss on the swivel case. I [l] FRICTION BLOCK PI CUTOUT / CAUTION Check the friction block disc surface for conta- mination with grease. Degrease if necessary. [3] BOSS I [4] SWIVEL CASE Check the 8 mm nylon washer, steering friction lever and the 8 mm washer for contamination with grease. [2] 8 mm SELF- LOCKING NUT PI STEERING FRICTION LEVER CAUTION If the 8 mm nylon washer, steering friction lever and/or the 8 mm washer is contaminated with grease, degrease the part securely.

WASHER I Install the 8 mm nylon washer, steering friction lever, 8 mm washer and the 8 mm self-locking nut. Turn the steering friction lever to the lock position (i.e. fully to the left until it contacts the stopper), and tight- en the 8 mm self-locking nut to the specified torque. TORQUE: 8.5 N.m (0.85 kgf-m, 6.1 Ibfeft) // [5] STOPPER 121 Install the long tiller handle assembly (P. 15-13). After assembly, check the starting torque by measur- ing the starting force at the center of the throttle grip using a spring scale (P. 3-8). 141 OCKING NUT Lever is in contact with stopper. S~EERING FRICTION LEVER 13-3