BF25D/30D BF25D-BF30D — Sep '94

BF25D.B F30D Tilt Lever Replacement CAUTION The gas assisted damper assembly contains nitro- gen gas and oil under high pressure. Do not disas- semble the gas assisted damper assembly. Oil escaping under high pressure may cause serious personal injury. r11 GAS ASSISTED DAMPER ASSEMBLY Gas Assisted Damper Disposal CAUTION Do not heat the gas assisted damper assembly, or it will explode. The gas assisted damper assembly contains nitro- gen gas and oil under high pressure. Do not dis- assemble the gas assisted damper assembly. Oil escaping under high pressure may cause serious personal injury. Dispose of the gas assisted damper assembly after releasing gas from it in the following proce- dure.

I) Set the tilt lever in the “TILT” position with the piston rod of the gas assisted damper assembly fully extended. 2) Wrap the gas assisted damper assembly inside a plastic bag and hold it upright in a vice as shown. 3) Through the open end of the plastic bag, insert a drill motor with a sharp 2 - 3 mm (5/64 - 1/8 in) drill bit. Hold the bag around the drill motor and briefly run the drill motor inside the bag; this will inflate the bag with air from the drill motor and keep the bag from getting caught in the bit when you start. Drill the plug bolt on the reservoir top to release the gas pressure. GAS ASSISTED ASSEMBLY CAUTION Drill only at the specified point.

Always wear eye protection to avoid getting metal shaving in your eyes when the gas pres- sure is released. The plastic bag is only intended to shield you from the escaping gas.