B F25D.B F30D 3. POWER TRIMRILT a. REMOVAL [I1 [2] 2P CONNECTOR POWER TRlMmlLT I Drain the carburetor by loosening the drain screws and remove the motor from the engine. ! a . 4 Gasoline is highly flammable and explosive. You can be burned or seriously injured when han- dling fuel. Keep heat, sparks and flame away. Handle fuel only outdoors. Wipe up spills immediately. 1) Remove the engine cover and CDI unit cover (P. 8-3 of the base shop manual). [5] HARNESS CLIP [4] WIRE HARNESS CLIP 2) Lay the outboard motor on its right side (i.e. with the carburetor side down).
3) With the right stern bracket raised off, operate the power trimhilt switch and set the swivel case in the uppermost position. After setting the outboard motor in the uppermost position, hold it in the position with the tilt stopper. 11 rRlM ANGLE [2] CONNECTORS / 4) Remove the power trimhilt motor wire. -Open the wire harness clip. -Release the wires from the two harness clips. -Remove the power trim/tilt motor 2P connector from the connector bracket and disconnect the connector. 5) Disconnect the trim angle sensor wire from the engine side. -Open the two wire harness clips. -Release the wires from the harness clip.
-Remove the trim angle sensor wire connector from the connector bracket and disconnect the connec- tor. [4] WIRG HARNESS CLIPS / [3] HARNESS CLIP [l] 14 mm CLIP 1 I \ /FiiOmrn 6) Remove the 5 x 10 mm rivet screw and remove the 14 mm clip. 7) Remove the engine under case grommet and pull off the wire from the engine under case. 13-6