BF25D.B F30D 8) Remove the power trimhilt motor wire and trim angle sensor wire from the left stern bracket. - Remove the spiral tube. - Open the wire harness clip. - Remove the harness band. - Remove the motor cord bushing and pull off the wires. [41 SPIRAL 9) Rem le th fire b 3 d remov the trim sensor wire from the power trimhilt assembly. I I [l] WIRE BAND (2) TRIM ANGLE SENSOR WIRE [3] WIRE BAND CLIP 10) Remove the 6 x 20 mm hex bolts and 6 mm washers, then remove the wire holder and trim angle sensor. [2] TRIM ANGLE SENSOR 11 1 6x20mm 13-7