B F25D.B F30D 11) Remove the 15 mm E-clip and remove the upper cylinder pin. 12) Remove the 8 mm self-locking nut, 8 mm washer and the 8 x 203 mm hex. bolt. 13) Loosen the 7/8-14 UNF self-locking nuts and raise the left stern bracket off. 14) Disconnect the ground cable and remove the power trim/tilt assembly. [3] 7/8-14 UNF SELF-LOCKING NUT (2) 8 mm WASHER L. STERN BRACK 4 - UPPER CYLINDER PIN R. STERN BRACKET COLLAR POWER TRIM/TILT 11 31 8 x 203 mm HEX. BOLT [8] GROUND CABLE ADJUSTING ROD I1 11 LOWER CYLINDER BUSHING p6GG-l [lo] DISTANCE COLLAR 13-8