Power Tridilt Switch 1) Remove the following. -Under cover (P. 15-3) -Throttle cable, shift cable (P. 15-3) -Throttle grip (P. 15-7) -Throttle rod (P. 15-7) After connecting the throttle rod (P. 15-7), operate the throttle grip and check that the power trimhilt switch wire does not interfere with the throttle rod. *I : Power trim/tilt type only *2: Except power trimhilt type [31 121 ‘1: WIRE COVER *1: 5 x 10 mm SCREW (2) *l : HARNESS BAND A (2) *2: SWITCH HOLE GROMMET [9] 5 mm WASHER [8] SWITCH BRACKET [71 *1: POWER TRIMRILT SWlT I INSPECTION: P.
15-11 Power Tridilt Switch Installation Install the power trimhilt switch with the “UP mark in the same side as the bolt installation hole side of the bracket. [l] SWITCH BRACKET [2] SWITCH GROMMET HOLE 15-9