BF25D/30D BF25D-BF30D — Sep '94

B F25D.B F30D 8) Connect the tiller handle wire harness 14P connector and set it on the connector bracket (Except mechani- cal tilt type) 11 1 TILLER HANDLE 121 14P CONNECTOR PI MAIN WIRE HARNESS Connect the emergency stop switch wire 2P connec- tor to the ICM wire 2P connector (Mecanical tilt type). 9) Clamp the tiller handle wire harness and main wire harness with the harness band clip. 141 CONNECTOR BRACKET [5] HARNESS BAND CLIP wire harness and main wire harness. 10) Set the 6 mm washers on the control cable shift pivot. Set the shift pivot on the throttle arm and shift link B, and install the 6 mm washers and 6 mm lock pins. After assembly, adjust the throttle cable and shift cable (P.

3-6 thru 3-8). [l] THROTTLE CABLE [2] SHIFT CABLE \ \ [3]6 mmWASHER(4) [4] 6 mm LOCK PIN (2) 15-1 4