BF25D/30D BF25D-BF30D — Sep '94

B F25D.B F30D c. LONG TILLER HANDLE INSTALLATION Set the long tiller handle assembly on the mount frame and tighten the two 10 mm washers and two 10 mm self-locking nuts. Tighten the two 10 mm self-locking nuts to the speci- fied torque. TORQUE: 34 N.m (3.5 kgf-m, 25 Ibf-ft) [11 LONG TILLER HANDLE ASSEMBLY [2] STEERING BRACKET [3] 10 mm WASHER (2) [4] 10 mm SELF-LOCKING NUT (2)’ 34 N.m (3.5 kgfm, 25 Ibf.ft) I Pass the tiller handle wire harness through the under case grommet A. [l] THROTTLE [2] SHtFT CABLE Pass the throttle cable and shift cable through the under case grommet A.

TILLER HANDLE WIRE HARNESS Pass the throttle cable through the inner side of the under case grommet A and the shift cable through the side close to the opening. Set the throttle cable and shift cable in the cable plate by aligning the groove in each cable with the cutout in the cable set plate. Set the under case grommet A, tiller handle wire har- ness, throttle cable and shift cable as a set in the engine under case. Secure the tiller handle wire harness with the wire band clip. Clamp the tiller handle wire harness. 15-1 3