Removing and installing piston with connecting rod Removing piston with connecting rod Fig. 1 Remove oil pan, oil suction pipe and cylinder heads. Remove bolts from connecting rod bearing cap. Take off connecting rod bearing caps with bearing shells, expediting the procedure by means of light strokes with a synthetic hammer if necessary. Note: Connecting rod bearing caps are match- marked with the connecting rod big ends; arrange them in corresponding order. 1 Figs. 2 and 3 Remove combustion residues (oil carbon) from top cylinder edge using a piece of hard wood. Caution: Do not damage cylinder liners. Push out connecting rod with piston in upward direction. Caution:
Do not damage oil spray nozzles. 2 3 Fig. 4 Lay pistons with connecting rods and associated caps aside; use deposit rack if available. Inspect pistons and piston rings visually. 4 135