MAN — Replacing cylinder liners

Replacing cylinder liners Removing cylinder liners Note: Observe oversizes for cylinder liner outer diameters and collar heights (see “Engineering S Data S Setting val- ues”). D Remove cylinder head, see page 104 D Remove pistons, see page 135 Figs. 1 and 2 1 Mark cylinder liner position relative to engine so that it can be reinstalled in the same position if re- used. Insert cylinder liner extractor device (special tool, see page 171, item 25) into cylinder liner, taking care not to damage the oil spray nozzle. 2 Fig. 3 Put support on extractor spindle and tighten nut. Hold extractor spindle in place and extract cylinder liner by turning nut. 3 Fig.

4 Take off extractor device and take out cylinder liner. 4 144