Replacing cylinder liners Fig. 5 Deposit cylinder liner upright. Take off O-rings. Number cylinder liners in order of installation. Checking cylinder liner protrusion Fig. 6 Clean basic bore and cylinder liner. Insert cylinder liner without O-rings into crankcase, observing the marking (ensure that it is identical with the position prior to removal). Measure cylinder liner protrusion at at least four different points, using gauge holder and gauge. 5 Note: If available, use measuring plate for the measurement (special tool, see page 174). Proceed as follows: D Position press-on measuring plate with turned collar facing the liner using 2 fit- ting sleeves to centre plate.
D Tighten 4 bolts (improvised: collar bolt 51.90020-0270, length shortened to 90 mm) on the press-on measuring plate in stages and crosswise to 40 Nm. D Set dial gauge combination above press-on plate to “0” under preload rel- ative to the crankcase. D Measure cylinder liner protrusion at least at four points. 6 A B Fig. 7 The cylinder liner protrusion is the difference be- tween the collar height and the collar recess in the crankcase. 1 Crankcase 2 Cylinder liner B − A = cylinder liner protrusion 1 2 7 Fig. 8 Install shim if the protrusion is below the minimum protrusion even at only one point. The shim is placed under the cylinder liner collar.
However, it may be used only if after installation the upper tolerance limit is not exceeded. 8 145