Removing and installing injection pump Fig. 12 Fit injection pump in such a way that the mounting bolts can be screwed in by hand. Check distance between injection pump and crankcase. 12 Fig. 13 Tighten mounting bolts to specified torque (see “Engineering S Data S Setting values”) 13 Fig. 14 Tighten bolts for fastening drive gear to drive flange consecutively to 5 Nm and then to 38 Nm. Note: Use only M8x22 mounting bolts (property class 12.9). For this, two complete turns of the engine are nec- essary. 14 Fig. 15 Check and, if necessary, adjust delivery start, see page 33). Close governor housing and fit timing case cover. Caution:
Comply with instructions for masking unions on pressurised oil and fuel pipes (see page 3). 15 42