Removing and installing thermostats and water pump Removing thermostats D Drain coolant, see page 49 D Remove heat exchanger, see page 60 Fig. 1 Remove cooling water neck (13 mm). Take out thermostat. Checking thermostats Check the function of the thermostats as follows. 1 D Hang thermostat in a pot filled with water D Heat water D Use suitable thermometer to ascertain the opening start and compare it with the set−point value given in “Engineering S Data S Setting val- ues”. D Measure opening stroke if necessary. Exchange defective thermostats. Fig. 2 Engines with remote thermostats have short-circuit elements (arrows) instead of thermostats in the water pump. 2 Removing water pump Fig.
3 D Take off V-belts, see page 151 Remove mounting bolts from water pump (13 mm) and take off water pump. 3 Installing water pump Fig. 4 Clean the sealing faces on water pump and engine housing using a scraper and fine abrasive paper. Stick the new seal for the water-pump housing to the crankcase using grease. 4 51