Checking and repairing pipe cluster for heat exchanger Fig. 5 The soldering А is to be effected on the side facing away from the engine coolant inlet Б . 1 2 5 2 Job instruction for soldering the deflectors on to the pipe cluster Each of the 4 outer pipes on the edges is to be cleaned with the aid of a brass brush / emery cloth in the area where the soldering is to be effected. The area must also be free of grease. To effect the soldering, use soldering tin DIN 1707 − L − SN 50 PB SB (MAN no. 09.43007−0092), melting range 183 _ C−215 _ C and soldering fluid such as DEGUSSA Soltaflux K or similar products from other manufacturers. The soldering burner is to be set for a soft flame.
At the soldering joint the parts are to be evenly heated but must not glow. The soldering fluid must remain “vitreous” and must not burn. 66