EPA07 MBE 4000 SERVICE MANUAL 12. Measure the crown of the main journals and the connecting-rod journals as listed in Table 1-13. See Figure 1-62. Figure 1-62 Measuring the Crown of the Journal 13. Regrind the main journals. After grinding, see Figure 1-60 for dimensions. [a] Check the outside diameter of each main journal. [b] Check the width of the center main journal. [c] Check the width of the remaining main journals. [d] Check the fillet radius of each main journal. [e] Check the crown of each main journal. [f] Check each main journal for out-of-round. 14. Regrind the connecting-rod journals. After grinding, check the following dimensions.
[a] Check the outside diameter of each connecting-rod journal. [b] Check the width of the each connecting-rod journal. [c] Check the fillet radius of each connecting-rod journal. [d] Check the crown of each connecting-rod journal. [e] Check each connecting-rod journal for out-of-round. 15. Install the crankshaft. Refer to section 1.10.2. [a] When the main bearing caps have been installed, measure the radial play (radial runout) of the crankshaft. Refer to section 1.10.2.2. [b] With the crankshaft fully installed, measure the end play (lateral runout) of the crankshaft. Refer to section 1.10.2.3. All information subject to change without notice.
DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-73