1.10 CRANKSHAFT ASSEMBLY 1.10.2.2 Checking of Crankshaft Radial Play Checking steps are as follows: 1. Clean the bearing races in the crankcase (cylinder block) and the bearing seats in the bearing caps with a chamois. NOTE: The center bearing shell halves must be mounted in the center crankcase race and bearing cap (fourth from either end). 2. Install the upper bearing shell on the bearing race in the crankcase. The locking lugs of the bearing shells must fit into the slots in the crankcase races. See Figure 1-63. 1. Crankcase Race 3. Cylinder Block 2. Upper Bearing Shell 4. Bearing Shells Locking Lug Figure 1-63 Upper Bearing Shell All information subject to change without notice.
1-74 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION