Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL NOTICE: Ensure that the mark on the crankshaft gear is aligned between the two marks on the camshaft gear and the dowel pin in the crankshaft gear is aligned with the dowel hole in the crankshaft. Failure to properly align the timing marks and dowel pin will cause improper operation of the engine and component damage. 8. Align the dowel pin in the crankshaft gear with the dowel pin hole in the crankshaft while aligning the timing marks on the camshaft gear and crankshaft gear and install gear. If necessary rotate the camshaft slightly until the two marked gear teeth on the camshaft gear are aligned with the marked tooth on the crankshaft gear. See Figure 1-73.

9. Install the flywheel housing. Refer to section 1.18.2. 10. Attach the rear engine mounts to the flywheel housing. Refer to the applicable vehicle service manual. 11. Remove the jack stands supporting the engine. 12. Install the oil pan. Refer to section 3.2.2. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-85