Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.10 CRANKSHAFT ASSEMBLY 5. Remove the flywheel housing. Refer to section 1.18.1. 1. Camshaft Gear 3. Dowel Pin 2. Crankshaft Gear Figure 1-72 Aligning the Marked Gear Teeth 6. Rotate the crankshaft until the marked gear tooth on the crankshaft gear is aligned between the two similarly marked teeth on the camshaft gear. See Figure 1-72. 7. Remove the crankshaft gear from the end of the crankshaft. If necessary, use a plastic hammer to loosen the gear. See Figure 1-73. 1. Crankshaft 3. Crankshaft Gear 2. Guide Pin Figure 1-73 Crankshaft Gear All information subject to change without notice. 1-84 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION