Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL [d] If the end play does not correspond to the calculated amount (in the example above: 0.0090 inch), replace the crankshaft. FALLING ENGINE To avoid injury from a falling engine, an adequate lifting device with a spreader bar and sling should be used to lift the engine. The sling and spreader bar should be adjusted so the lifting hooks are vertical to prevent bending the lifter brackets. To ensure proper weight distribution, all provided lifter brackets must be used. NOTICE: A spreader bar must be used at all times in conjunction with the front and rear lifter brackets to lift the EGR engine to ensure that no engine damage will result.

The brackets are designed to lift vertically. 7. Install the engine in the vehicle. 1.10.3 Replacement of Crankshaft Gear Replacement steps are as follows: 1. Remove the transmission and clutch. Refer to the appropriate vehicle service manual. 2. Remove the oil pan and gasket. Refer to section 3.2.1. 3. Support the engine by placing suitable jack stands under the cylinder block pan rails. Make sure not to damage the sealing surfaces of the pan rails. 4. Remove the rear engine mounts from the flywheel housing. Refer to the applicable vehicle service manual. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-83