Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.10 CRANKSHAFT ASSEMBLY [c] From the value for the journal width, subtract the value for the bearing shell width. This result is the end play. Example: W m s = 0.0090 inch. NOTE: In the above example, both measurements belonged to repair stage "Standard." If necessary, listed in Table 1-20 are the correct repair stages for each measurement. Table 1-20 Bearing Shell and Bearing Journal Width 5. Install the crankshaft. Refer to section 1.10.2. 6. Using a dial gauge and holder, measure the end play of the crankshaft. Measure at the front end of the crankshaft, with the crankshaft fully installed and all the bearing caps tightened to the correct torque. See Figure 1-71. 1. Dial Gauge 3.

Crankshaft 2. Dial Gauge Holder 4. Screwdriver Figure 1-71 Measuring the End Play of the Crankshaft [a] Set up a dial gauge and a dial gauge holder on the front end of the crankshaft. Set the dial gauge to 5 mm (0.2 in.) preload. [b] Move the crankshaft all the way forward by prying on one of the bearing caps, then reset the dial gauge to "0" (zero). [c] Move the crankshaft all the way aft. Note the end play on the dial gauge. All information subject to change without notice. 1-82 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Size:

mm (in.) Center Bearing Shell Width mm (in.) Center Bearing Journal Width mm (in.) Standard 45.74-45.81 (1.801-1.804) 46.000-46.062 (1.8110-1.8135) Undersize - 0.020 (0.50) 46.24-46.31 (1.820-1.823) 46.500-46.562 (1.8307-1.8331) Undersize - 1.00 (0.040) 46.74-46.81 (1.840-1.843) 47.000-47.062 (1.8504-1.8528)