EPA07 MBE 4000 SERVICE MANUAL 3. Check the width of the center main bearing shell. If damage or cracks are present, replace the crankshaft. See Figure 1-70. Figure 1-70 Measuring the Width of the Center Main Bearing Shell NOTE: To obtain a correct value for crankshaft end play, the width of each bearing shell and its corresponding journal must belong to the same repair stage (both must be "Standard," "Undersize - 0.020 in.," etc.). 4. Calculate the end play, or axial play, (fore-to-aft movement) of the crankshaft. If the end play is less than 0.190 mm (0.0075 in.), or more than 0.322 mm (0.0127 in.) as listed in Table 1-19, then replace the crankshaft.
Table 1-19 Crankshaft End Play [a] For the center main bearing journal, note the width (thickness) of the bearing journal. Example: W m = 1.8120 in. [b] For the center main bearing shell, note the width (thickness) of the bearing shell. Example: W s =1.8030 in. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-81 Description Dimensions mm (in.) End Play (Axial Play) Measured at Center Bearing Journal 0.190-0.322 (0.0075-0.0127)