1.10 CRANKSHAFT ASSEMBLY To avoid injury from a falling engine, an adequate lifting device with a spreader bar and sling should be used to lift the engine. The sling and spreader bar should be adjusted so the lifting hooks are vertical to prevent bending the lifter brackets. To ensure proper weight distribution, all provided lifter brackets must be used. FALLING ENGINE A spreader bar must be used at all times in conjunction with the front and rear lifter brackets to lift the EGR engine to ensure that no engine damage will result. The brackets are designed to lift vertically. NOTICE: 12. Install the engine in the vehicle. 1.10.2.3 Checking of Crankshaft End Play Checking steps are as follows:
1. Remove the crankshaft. Refer to section 1.10.1. 2. Check the width of the center main bearing journal. If damage or cracks are present, replace the crankshaft. See Figure 1-69. Figure 1-69 Measuring the Width of the Center Journal All information subject to change without notice. 1-80 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION