Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 9. Using a micrometer, measure the outside diameter of the main journals. See Figure 1-68. 1. Micrometer 2. Main Journal Figure 1-68 Outside Diameter of the Main Journals NOTE: To obtain a correct value for crankshaft radial play, the diameters of each bearing bore and its corresponding journal must belong to the same repair stage (both must be "Standard," "Undersize - 0.004 in.," etc.). 10. Calculate the radial play (up-and-down movement) of the main bearings on the crankshaft journals.If the radial play is less than 0.060 mm (0.0024 in.), or more than 0.126 mm (0.0050 in.) as listed in Table 1-18, then replace the crankshaft.

Table 1-18 Crankshaft Radial Play [a] For the main bearing shell, note the inside diameter of the bearing shell. Example: D s = 4.0875 in. [b] For the main bearing journal, note the outside diameter of the journal. Example: D j = 4.0850 in. [c] From the value for the bearing shell diameter, subtract the value for the journal diameter. This result is the radial play. Example: D s j = 0.0025 in. NOTE: In the above example, both measurements belonged to repair stage "Undersize - 0.010 in." Listed in Table 1-17is the correct repair stage for each measurement. 11. Install the crankshaft into the crankcase. Refer to section 1.10.2. All information subject to change without notice.

DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-79 Description Dimensions mm (in.) Main Journal Radial Play 0.060-0.126 (0.0024-0.0050)