1.10 CRANKSHAFT ASSEMBLY [c] Measure 30 degrees clockwise from the separation point of the bearing shells. (see Figure 1-67, C.) 1. Bearing Cap Bolts 3. Main Bearing Shell 2. Main Bearing Cap 4. Crankcase Race Figure 1-67 Inside Diameter of the Main Bearing Shells 7. If any one of the readings is not within tolerances listed in Table 1-17, then replace the main bearing shells as applicable. Table 1-17 Bearing Shell and Bearing Journal Diameter NOTE: New bearing shells are supplied ready for installation. Do not machine them or remove any material from them. Refer to section 1.10.2. 8. Remove the bearing caps. NOTE: If the bolts are going to be used again, check their length.
All information subject to change without notice. 1-78 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Size:
mm (in.) Main Bearing Inside Diameter mm (in.) Main Journal Outside Diameter mm (in.) Standard 104.060-104.106 (4.0968-4.0987) 103.980-104.000 (4.0937-4.0945) Undersize - 0.10 (0.004) 103.960-104.006 (4.0929-4.0947) 103.880-103.900 (4.0898-4.0905) Undersize - 0.25 (0.010) 103.810-103.856 (4.0870-4.0888) 103.730-103.750 (4.0839-4.0846) Undersize - 0.50 (0.020) 103.560-103.606 (4.0772-4.0790) 103.480-103.500 (4.0740-4.0748) Undersize - 0.75 (0.030) 103.310-103.356 (4.0673-4.0691) 103.230-103.250 (4.0642-4.0650) Undersize - 1.00 (0.040) 103.060-103.106 (4.0575-4.0593) 102.980-103.000 (4.0543-4.0551)