Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 5. Lubricate the main bearing cap bolts with a light coating of clean engine oil. Install them on the main bearing caps. See Figure 1-66. Refer to section 1.10.2 for instructions and tightening torques. 1. Cylinder Block 3. Bearing-Cap Bolt 2. Main Bearing Cap 4. Crankshaft Gear Figure 1-66 Main Bearing Caps 6. Using a dial gauge and quick-release calipers, measure the inside diameter of each of the main bearings. See Figure 1-67. [a] Measure vertically from the top to the bottom of the bore. (see Figure 1-67, A.) [b] Measure 30 degrees counterclockwise from the separation point of the bearing shells.

(see Figure 1-67, B.) All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-77