EPA07 MBE 4000 SERVICE MANUAL 3. Remove the front engine mounting bolts attaching the front cover housing to the front crossmember. NOTICE: To prevent damage to the oil pan, protect the pan by placing a board on the jack lifting surface. 4. Using a floor jack, lift up the oil pan. 5. Remove the vibration damper and pulley from the engine through the opening in the bumper. Refer to section 1.13.1. 6. Remove the mounting bolts attaching the front cover housing to the block. Remove the front cover housing from the cylinder block. Remove and discard the cover housing gasket. See Figure 1-74. 7. Remove the front radial seal from the front cover housing.
1.11.2 Installation of Front Cover Housing Installation steps are as follows: 1. Install a new gasket on the cylinder block. See Figure 1-74. 2. Lubricate the seal race on the crankshaft with a light coating of engine oil. 3. Install the front cover on the cylinder block. Tighten the front cover mounting bolts 60 N·m (44 lb·ft). 4. Install the front radial seal. Refer to section 1.7.2. 5. Install the oil deflector on the front of the crankshaft. 6. Install the vibration damper and pulley on the crankshaft. Torque the vibration damper mounting bolts 200 N·m (148 lb·ft). Refer to section 1.13.2. 7. Lower the oil pan and remove the floor jack. 8.
Install the front engine mounting bolts attaching the front cover housing to the front crossmember. Torque the front engine mounting bolts 325 N·m (240 lb·ft). 9. Close the hood, and remove the chocks from the tires. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-87