Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.12 CRANKSHAFT POSITION SENSOR 1.12 CRANKSHAFT POSITION SENSOR The Crankshaft Position (CKP) sensor is located on the rear of the flywheel housing and is used to indicate specific cylinder positions and engine speed. 1.12.1 Replacement of Crankshaft Position Sensor Replacement steps are as follows: 1. Disconnect the electrical connector. See Figure 1-75. 1. Camshaft Position Sensor 2. Crankshaft Position Sensor Figure 1-75 Crankshaft Position Sensor 2. Pull outward to remove the sensor from the access hole in the flywheel housing. 3. Install a new sensor in the flywheel housing. Push the sensor in until it is fully seated. 4. Connect the electrical connector to the CKP sensor. NOTE:

Be sure that the correct electrical connector is connected to the CKP sensor. All information subject to change without notice. 1-88 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION