EPA07 MBE 4000 SERVICE MANUAL 1.13 CRANKSHAFT VIBRATION DAMPER AND PULLEY The following sections support the crankshaft vibration damper and pulley. 1.13.1 Removal of Crankshaft Vibration Damper and Pulley Removal steps are as follows: 1. Remove the fan belt from the vibration damper. Refer to section 9.1.3. 2. Remove the main drive belt from the alternator, coolant-pump, idler, and air-conditioner compressor pulleys. Refer to section 9.1.1. 3. Remove the inspection cover from the flywheel housing and install the engine barring tool (J–46392), with the locking pin in place. Refer to section 1.17.2. 4.
To gain access to the vibration damper, remove the lower mounting bolts from the bottom of the front fairing/bumper. 5. Remove the mounting bolts from the vibration damper and pulley. Drop the vibration damper and pulley down below the radiator and remove it from the engine. See Figure 1-76. 1. Mounting Bolts 3. Oil Deflector 2. Vibration Damper and Pulley Figure 1-76 Vibration Damper and Pulley 6. Remove the oil deflector from the crankshaft. 7. Inspect the vibration damper and pulley for signs of wear, dents, deformation, or other signs of damage. Replace the damper and/or pulley if damaged. All information subject to change without notice.
DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-89