1.13 CRANKSHAFT VIBRATION DAMPER AND PULLEY 1.13.2 Installation of Crankshaft Vibration Damper and Pulley Installation steps are as follows: NOTE: Check the crankshaft front seal for oil leaks. If leakage is found, replace the front seal. Refer to section 1.7. 1. Install the oil deflector. Ensure the rim is facing the engine. 2. Install the vibration damper and pulley on the crankshaft. Torque the bolts to 200 N·m (148 lb·ft). See Figure 1-76. 3. Install the main drive belt on the alternator, coolant-pump, idler, and air-conditioner compressor pulleys. Refer to section 9.1.2. 4. Install the fan belt on the vibration damper. Refer to section 9.1.4. 5. Remove the engine barring tool (J–46392).
Refer to section 1.17.2. 6. Install the lower mounting bolts on the bottom of the front fairing/bumper, as removed. All information subject to change without notice. 1-90 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION