Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.14 FLYWHEEL To avoid injury from a falling flywheel when removing the last bolt, hold the flywheel against the crankshaft by hand to prevent it from slipping off the crankshaft. The flywheel is not doweled to the crankshaft. FALLING FLYWHEEL FALLING COMPONENT To avoid injury from a falling component, ensure a proper lifting device is used. 7. Remove the remaining eight flywheel bolts. 8. Remove the engine barring tool (J–46392). Refer to section 1.17.2. 9. Remove the flywheel, leaving the guide pins (J–46172) in place. See Figure 1-80. [a] On opposite sides of the bolt circle, screw a bolt into each of two threaded clutch bolt holes.

[b] Using the two bolts as handles, dislodge the flywheel from the crankshaft flange and remove it from the flywheel housing. [c] After removing the flywheel, remove the bolts from the clutch bolt holes. 10. Inspect the flywheel bolts. Replace the bolts if any of the shanks are stretched beyond the maximum length of 77.0 mm (3.03 in.). See Figure 1-81. 1. Shank Figure 1-81 Measuring the Flywheel Bolts All information subject to change without notice. 1-94 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION