Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 11. Thoroughly clean the flywheel and check the clutch surface for cracks, burned spots, or scoring. If the damage exceeds the maximum depth of stock, replace the flywheel. Refer to section 1.14.1.2. 12. Inspect the flywheel flange for signs of wear or traces of hollowing caused by the radial seal. 13. Inspect the flywheel ring gear for damaged teeth or signs of wear. Replace the ring gear if necessary. Refer to section 1.15.1. 1.14.1.1 Inspection of Flywheel Inspection steps are as follows: 1. Remove the flywheel. Refer to section 1.14.1. 2. Thoroughly clean the flywheel and check it for cracks, scoring, burned areas, or rough spots. 3.

Using an accurate straightedge and a feeler gauge, check the friction (clutch) surface for evenness. See Figure 1-82. If the surface has areas that are too high or too low, replace the flywheel. 1. Straightedge 2. Friction Surface Figure 1-82 Checking the Friction Surface for Evenness 4. Check the bearing surface and the threaded holes for wear and damage. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-95