1.14 FLYWHEEL 1.14.1.2 Machining of Flywheel Machining steps are as follows: NOTE: Before beginning any machining work on the flywheel, check it to see if machining is possible. If the scores or cracks are deeper than 1 mm (0.04 in.), replace the flywheel. If the width of the flywheel between the friction surface and the mounting flange is less than 60 mm (2.4 in.), replace the flywheel. PERSONAL INJURY To avoid injury while performing the test or procedure, wear adequate eye, face protection, and heat-resistant gloves. 1. Machine the flywheel friction surface, if required, to the specifications listed in Table 1-21. See Figure 1-83.
The surface finish (peak-to-valley height) after machining should be 0.016 mm (0.006 in.). A rougher surface finish will cause rapid clutch lining wear, while a smoother finish could cause difficulties in clutch disengagement. See Figure 1-84 for the locations on the flywheel to coordinate with the specifications in the table. Figure 1-83 Machining the Flywheel Friction Surface All information subject to change without notice. 1-96 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION