1.14 FLYWHEEL 1.14.2 Installation of Flywheel Installation steps are as follows: 1. Grease the ring gear with a suitable heavy-duty grease. 1. Pilot Bearing 3. Flywheel 2. Spacer Ring Figure 1-85 Pilot Bearing and Spacer Ring FALLING COMPONENT To avoid injury from a falling component, ensure a proper lifting device is used. NOTICE: Ensure that the spacer ring is installed in the flywheel to prior to installing the flywheel on the crankshaft. Failure to install the spacer ring will result in improper operation of the transmission. 2. Ensure that the spacer ring is installed in the flywheel to prior to installing the flywheel on the crankshaft. See Figure 1-85. 3.
Install guide pins (J–46172) then install the flywheel over the guide pins. Align the dowel on the crankshaft with the guide hole in the flywheel (arrow). See Figure 1-86. All information subject to change without notice. 1-98 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION