EPA07 MBE 4000 SERVICE MANUAL 4. Install the engine barring tool (J–46392) in the flywheel housing and secure with two bolts. Insert the pin and make sure the tool is blocked. Refer to section 1.17.2. Figure 1-86 Flywheel Alignment Mark NOTE: Verify the alignment of the crankshaft dowel with the guide hole in the flywheel. 5. With a light coating of engine oil, lubricate the threads of the ten multipoint socket-head flywheel bolts. 6. Using the 19-mm socket (J–45390), tighten the eight bolts in two stages. In each stage, use an alternate sequence to tighten the bolts, as listed in Table 1-22.
Table 1-22 Tightening Stages, Flywheel Mounting Bolts [a] Install eight bolts to hold the flywheel in position. [b] Remove the two guide pins (J–46172) and install the two remaining bolts in their place. [c] Tighten the bolts, in an alternate tightening sequence, 200 N·m (147.5 lb·ft). [d] Using the same tightening sequence, turn the flywheel bolts 90 degrees. 7. Remove the engine barring tool (J–46392). Install the inspection cover on the flywheel housing with two bolts. Tighten the bolts 25 N·m (18 lb·ft). 8. Install the Crankshaft Position (CKP) sensor into the flywheel housing. Refer to section 1.12.1. 9. Install the clutch on the flywheel. Install the transmission.
All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-99 Max. Shaft Length, mm (in.) Tightening Stage Torque N·m (lb·ft) 77.0 (3.03) Stage 1 200 (147.5) 77.0 (3.03) Stage 2 90 degrees