Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 1.17.2 Removal of Engine Barring Tool Removal steps are as follows: 1. Remove the two bolts and the engine barring tool from the flywheel housing. It is not necessary to remove the pin. 2. Install the inspection cover on the flywheel housing with the two bolts. Tighten the bolts 25 N·m (18 lb·ft). NOTICE: The engine barring tool must be removed from the timing case before starting the engine. Failure to do so could damage the flywheel ring gear. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-109