Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.17 ENGINE BARRING TOOL 1.17 ENGINE BARRING TOOL A special tool is required for this procedure: Engine Barring Tool (J–46392) which is used for two separate functions, locking and barring.. With the pin inserted, the tool blocks the flywheel ring gear to prevent rotation during removal and installation of the flywheel. Without the pin, the tool can be used with a wrench to turn the flywheel and crankshaft manually. NOTE: The first time an engine barring tool is installed on the engine to turn the flywheel, the teeth on the rotating gear may rub on the flywheel housing. This does not cause a problem and should not occur the next time the tool is used.

1.17.1 Installation of Engine Barring Tool Installation steps are as follows: 1. Remove the two bolts holding the inspection cover to the flywheel housing. See Figure 1-95. 1. Inspection Cover Figure 1-95 Engine Barring Tool 2. Remove the pin from the engine barring tool (J–46392). 3. Install the tool in the flywheel housing and secure with two bolts of sufficient length. NOTE: The inspection cover bolts are not long enough to install the engine barring tool. Longer ones will be needed. 4. As needed, insert the pin to lock the tool and block movement of the flywheel ring gear. All information subject to change without notice. 1-108 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION