EPA07 MBE 4000 SERVICE MANUAL 6. Tighten the flywheel bolts in two stages. In each stage, use an alternate sequence to tighten the bolts, as listed in Table 1-24. Table 1-24 Flywheel Mounting Bolts Tightening Stages 7. Remove the engine barring tool (J-46392). Refer to section 1.17.2. 8. Install the clutch on the flywheel. Refer to the appropriate vehicle service manual. 9. Install the transmission. Refer to the appropriate vehicle service manual. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-107 Max. Shaft Length, mm (in.) Tightening Stage Torque Value, N·m (lb·ft) 77.0 (3.03) Stage 1 200 (147.5) 77.0 (3.03) Stage 2 90 degrees