Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.16 PILOT BEARING 10. Clean the pilot bearing bore in the flywheel and inspect for damage or spun bearing, replace flywheel if damage is found. 1.16.2 Installation of Pilot Bearing Installation steps are as follows: NOTICE: Ensure that the spacer ring is installed prior to installing the pilot bearing in the flywheel. Failure to install the spacer ring will result in improper operation of the transmission. 1. Ensure that the spacer ring is installed in the flywheel prior to installing the pilot bearing. See Figure 1-94. 2. Using the flywheel pilot bearing installer (J-46169) and driver handle (J-8092), position the bearing on the flywheel and drive it into the flywheel until seated.

See Figure 1-94. 1. Pilot Bearing 3. Flywheel 2. Spacer Ring 4. M16 x 1.5 x 70mm Hex-Head Bolt Figure 1-94 Pilot Bearing 3. Lubricate the flywheel bolts with a light coat of engine oil. 4. Install two standard flywheel bolts, finger tight, perpendicular to the M16 x 1.5 x 70mm bolts. Remove the special bolts. 5. Install the remaining eight flywheel bolts. All information subject to change without notice. 1-106 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION