Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 1.19.1 Removal of Piston Removal steps are as follows: 1. Remove the oil pan. Refer to section 3.2.1. NOTE: The MBE 4000 engine has individual heads for each cylinder. To remove one piston, do these procedures step by step. To remove all the pistons, repeat each step in these instructions, as applicable, for all six pistons. 2. Remove each cylinder head, as required. Refer to section 1.3.1. NOTICE: Do not damage the piston travel surface of the cylinder. 3. Using a plastic scraping tool, carefully scrape off any combustion residues from the combustion area in the cylinder in order to avoid damage to the piston rings when the piston is removed. 4.

Install the engine barring tool (J–46392). Refer to section 1.17.1. 5. Be sure the connecting rods and the bearing caps are marked so that they can be matched for installation. See Figure 1-98. 1. Bearing Cap 2. Connecting Rod Figure 1-98 Checking Rod and Bearing Cap Markings All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-113