EPA07 MBE 4000 SERVICE MANUAL 3. Install the two matched halves of the bearing shell, as marked on removal, into the connecting rod and into the bearing cap. Be sure the locking lugs on the bearing shells fit into the grooves in the rod and cap. See Figure 1-106. 1. Connecting Rod 3. Bearing Cap 2. Bearing Shell (2 halves) 4. Connecting Rod Bolt Figure 1-106 Bearing Shell Replacement 4. Install the bearing cap on the connecting rod, pressing it on by hand. Be sure that the marks on the cap and rod match. 5. Lubricate the threads and the contact surface of the head of each stretch bolt with a light coating of engine oil. 6.
Install the stretch bolts in the connecting rod, and tighten them alternately. Tighten each one in turn to the first stage and then go on to the next stage, listed in Table 1-28. Table 1-28 Connecting Rod Stretch Bolts Tightening Stages All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-121 Max. Shaft Length mm (in.) Tightening Stage Torque Value N·m (lb·ft) 68.5 (2.70) Stage 1 108 (80) 68.5 (2.70) Stage 2 additional 90 degrees