1.19 PISTON, PISTON RING, AND CONNECTING ROD the connecting-rod centerline (Dimension C in see Figure 1-105). The maximum allowed difference is 0.030 mm (0.0012 in.). [c] Measure the diameter of the connecting rod basic bore, with the bearing shells removed. The diameter of the basic bore must be between 99.000-99.022 mm (3.8976-3.8985 in.). [d] Measure the maximum permissible out-of-round in the bearing bore, with the bearing shells removed. The maximum permissible is 0.01 mm (0.0004 in.). 5. Calculate the connecting rod end play (fore-to-aft movement) on the crankshaft. If the end play is less than 0.130 mm (0.0051 in.), or more than 0.292 mm (0.0115 in.), replace the connecting rod.
Listed in Table 1-27 Table 1-27 Connecting Rod Bearing Play Specifications [a] For each bearing journal, note the width (thickness) of the bearing journal. Example: W j = 1.8120 in. [b] For each connecting rod, note the width (thickness) of the rod. Example: W r = 1.8050 in. [c] From the value for the journal width, subtract the value for the connecting rod width. This result is the end play. Example: W j minus W r = 0.0070 in. 6. Remove the bolts and bearing cap when ready to install the piston. 7. Install the piston. Refer to section 1.19.2. 1.19.1.3 Measurement of Connecting Rod Radial Play Measurement steps are as follows: 1. Remove the piston. Refer to section 1.19.1. 2.
Using a chamois cloth, clean the bearing bores in both the connecting rod and the bearing cap. All information subject to change without notice. 1-120 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Description Dimensions: mm (in.) Radial Play 0.054 - 0.116 (0.0021 - 0.0046) End Play (axial play) 0.130 - 0.292 (0.0051 - 0.0115)