Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL NOTICE: Do not attempt to straighten the connecting rod. This could result in severe engine damage. 4. Inspect the connecting rod for twisting and dimensional tolerance, see Figure 1-105. If any value exceeds those listed in Table 1-26, replace the connecting rod. Figure 1-105 Connecting Rod Measurements Table 1-26 Connecting Rod Dimensional Tolerances [a] On each side of the connecting rod, measure the length of the connecting rod (Dimension A in see Figure 1-105) : the distance from the center bearing bore (big-end bore) to the center of the bushing (small-end bore). The measurement must be within 255.970-256.030 mm (10.0776-10.0799 in.).

[b] Measure the difference in axial parallelism (Dimension B in see Figure 1-105) between the bearing bore and the inner surface of the bushing, at 50 mm (2 in.) from All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-119 Description Dimensions:

mm (in.) Length of Connecting Rod 255.970-256.030 (10.0776-10.0799) Basic Bore Diameter for Connecting Rod Bearings 99.000-99.022 (3.8976-3.8985) Maximum Permissible Out-of-Round in Bearing Bore 0.01 (0.0004) Maximum Permissible Out-of-Round in Bushing Bore 0.01 (0.0004) Maximum Difference in Axial Parallelism Between Bearing Bore and Bushing Inner Surface 0.030 (0.0012) Width of Connecting Rod (at big end) 44.308-44.370 (1.7444-1.7468) Width of Connecting Rod Journal 44.5-44.6 (1.75-1.76) Distance from Connecting Rod Center Line for Measuring Parallelism 50 (2)