1.19 PISTON, PISTON RING, AND CONNECTING ROD 3. Measure the inside diameter of the bushing in the small bore of the connecting rod. Use a quick-release caliper (internal measurement, 40-60 mm) [1.57-2.36 in.], with a dial gauge and holder. If the value exceeds 52.07 mm (2.050 in.), replace the connecting rod. 1. Dial Gauge 5. Bearing Shell (2 halves) 2. Dial Gauge Holder 6. Bearing Cap 3. Bushing 7. Stretch Bolt (2 qty.) 4. Connecting Rod Figure 1-104 Connecting Rod Inside Diameters NOTE: Checking the connecting rod for a twisted or bent condition in the next step requires machine shop equipment such as a caliper gauge with a round scale. All information subject to change without notice.
1-118 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION