Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 4. Check the tolerance code on the piston and compare it to the tolerance code on the cylinder liner. See Figure 1-103. for location of tolerance codes. 1. Piston 2. Cylinder Liner Figure 1-103 Tolerance Codes [a] Cylinder liners with tolerance code A require a piston of code BA. [b] Cylinder liners with tolerance code B require a piston of either code BA or BC. [c] Cylinder liners with tolerance code C require a piston of code BC. 5. Check the condition of the piston rings. Replace any worn, damaged, or chipped rings. Refer to section 1.19.3. 6. Check the connecting rod for any unusual condition. Refer to section 1.19.1.2. 7.

Measure the diameters of the bearing shell bore and crankshaft journals. Refer to section 1.19.1.3 for instructions. 8. Check the length of the connecting rod stretch bolts. Replace any bolts that exceed the maximum length of 68.5 mm (2.70 in.). 1.19.1.2 Measurement of Connecting Rod End Play Measurement steps are as follows: 1. Remove the piston. Refer to section 1.19.1. 2. Inspect the connecting rod for blue discoloration (indicates bearing damage), scoring, notches, and cracks. If any of these conditions are found, replace the connecting rod. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-117