Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.19 PISTON, PISTON RING, AND CONNECTING ROD 1.19.1.1 Inspection of Piston Inspection steps are as follows: 1. Remove the piston. Refer to section 1.19.1. 2. Check the diameter of the wrist pin and the wrist pin bore. See Figure 1-102. Specifications are listed in Table 1-25. 1. Piston and Rings 5. Bearing Cap 2. Wrist Pin 6. Connecting Rod Stretch Bolt 3. Snap Ring 7. Bearing Shell 4. Connecting Rod Figure 1-102 Piston and Related Components Table 1-25 Piston Inspection Specifications 3. Inspect the cylinder liner and piston for damage and signs of wear. Replace any piston with damage to the snap ring grooves, cracks in the piston wall, or signs of seizing and/or erosion.

All information subject to change without notice. 1-116 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Description Dimensions: mm (in.) Piston Compression Height 79.50-79.55 (3.130-3.132) Wrist Pin Bore Diameter 52.03-52.04 (2.0484-2.0488) Wrist Pin Diameter 51.992-51.998 (2.0469-2.0472)