EPA07 MBE 4000 SERVICE MANUAL 9. Remove the carbon scraper ring from the cylinder liner groove. 1. Cylinder Liner 3. Installed Piston 2. Carbon Scraper Ring 4. Installed Carbon Scraper Ring Figure 1-101 Carbon Scraper Ring 10. Push the piston and connecting rod out of the cylinder, and remove them both from the cylinder block. 11. Secure the connecting rod in a vise with protective jaws. NOTICE: Be sure the vise jaws are adequately lined to prevent the rod surface from being nicked or marred in any way. Such surface damage could lead to later rod cracking or breaking. 12. Remove the piston rings from the piston. Refer to section 1.19.3. 13. Remove the wrist-pin snap rings.
Push the wrist pin out and remove the piston from the connecting rod. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-115