EPA07 MBE 4000 SERVICE MANUAL [c] Calculate the average (nominal) bearing-journal diameter from these two measurements, and determine the current repair stage listed in Table 1-30. Table 1-30 Bearing Bore Inside Diameter with Bearing Shells Installed NOTICE: Be sure the vise jaws in the next step are adequately lined to prevent the connecting rod surface from being nicked or marred in any way. Such surface damage could lead to later cracking or breaking of the rod. 8. Place the connecting rod in a vise with protective jaws. To prevent the rod from twisting excessively, position the rod in the vise as close as possible to the big-end bore. 9.
Set the caliper internal measurement 80-100 mm (3.15-3.94 in.) to the nominal bearing-journal diameter calculated above. Use a 75-100 mm micrometer (2.95-3.94 in.) for the setting. Preload the setting 5 mm (0.2 in.). See Figure 1-108. Figure 1-108 Setting the Caliper 10. Using a quick-release caliper (internal measurement 80-120 mm [3.15-4.72 in.]), dial gauge, and holder, measure the inside diameter of the bearing bore (with the shells installed) at three points. Measure vertically and about 60 degrees each side of vertical. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-123 Repair Stage: mm (in.) Diameter:
mm (in.) Standard 94.054-94.096 (3.7029-3.7046) Undersize - 0.10 (0.004) 93.954-93.996 (3.6990-3.7006) Undersize - 0.25 (0.010) 93.804-93.846 (3.6931-3.6947) Undersize - 0.50 (0.020) 93.554-93.596 (3.6832-3.6848) Undersize - 0.75 (0.030) 93.304-93.346 (3.6734-3.6750) Undersize - 1.00 (0.040) 93.054-93.096 (3.6635-3.6652)