1.19 PISTON, PISTON RING, AND CONNECTING ROD See Figure 1-109 to locate the measuring points, and find the current specifications listed in Table 1-30. 1. Bolt 2. Bearing Cap Figure 1-109 Measuring the Inside Diameter of the Bearing Shell [a] Measure the bearing bore in the vertical dimension and note the reading. [b] Mark off a point 60 degrees counterclockwise from vertical. Measure the bearing bore in this dimension and note the reading. [c] Mark off a point 60 degrees clockwise from vertical. Measure the bearing bore in this dimension and note the reading.
[d] Calculate the average (nominal) bearing-journal diameter from these three measurements, and determine the current repair stage listed in Table 1-30. If any of the measurements are out of tolerance, replace the bearing shells. NOTE: Connecting-rod bearings for all repair stages are delivered from the factory ready to install. Do not refinish them in any way. NOTE: To obtain a correct value for connecting-rod radial play, the diameters of each bearing bore and its corresponding journal must belong to the same repair stage (both must be "standard," "undersize 0.1 mm," etc.). All information subject to change without notice. 1-124 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION