Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 11. Calculate the connecting rod radial play (up-and-down movement) at the bearing journal. If the radial play is less than 0.054 mm (0.0021 in.), or more than 0.116 mm (0.0046 in.), replace the connecting rod. Listed in Table 1-31is the radial play. Table 1-31 Connecting Rod Radial Play [a] For each connecting rod, note the average value for the bearing bore diameter, as calculated. Example: D s = 3.5421 in. [b] For each bearing journal, note the average value for the bearing journal diameter, as calculated. Example: D j = 3.5391 in. [c] From the value for the bearing bore diameter, subtract the value for the bearing journal diameter.

This result is the radial play. Example: D s minus D j = 0.0030 inch. NOTE: In the above example, both measurements belonged to repair stage "undersize 0.1 mm." 12. Remove the bearing cap from the connecting rod. 13. Install the piston. Refer to section 1.19.2. 1.19.2 Installation of Piston Installation steps are as follows: NOTICE: The carbon scraper ring has a smaller internal diameter than the piston skirt diameter; therefore, the piston installation and removal must be carried out with the carbon scraper ring uninstalled or removed. NOTE: Piston installation in the EGR engine is performed with the engine facing upright – not turned on its side. 1.

Position the connecting rod in the piston so that the longer end side is on the unit pump side (left side), and arrow on piston, if present, points toward the front of the engine. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-125 Description Dimensions: mm (in.) Radial Play 0.054 - 0.116 (0.0021 - 0.0046)